Wire for IKELITE housing/2x IKELITE flash IKE 45152
Ikelite twisted sync cable for connection between Ikelite subwoofer and two Ikelite flash units.
Allows transmission of the TTL.
- 1 Ikelite / Ikelite spindle protection cap (IKE 0301
- 1 single pin protection cap (IKE 0301.12
- 1 Ikelite 1cc silicone grease trap
- The blue identification ring at one end of the cable indicates that the cord is compatible with the TTL mode
- The side of the cord with the red ring is used to connect the 2nd flash (slave flash).
- Never connect this cord with a non-TTL compatible flash
- After use, disconnect the cord from the flash (s), lightly lubricate the seal and replace the protective cap of the pins to prevent any risk of pin seizure in the flash.